How do I fix Samsung dishwasher error LE?

Step 1: Identify the leak location. Step 2: Check the door seal. Step 3: Inspect hose connections. Step 4: Check for proper loading. Step 5: Inspect the tub/sump. Step 6: Replace the door gasket or tighten fittings

Samsung Dishwasher serious

LE Leak sensor activated

The Samsung LE error code on your dishwasher indicates: Leak sensor activated. This typically requires troubleshooting the leak system.

Reported on: DW80R5060USDW80R9950USDW80K5050US

Diagnosis

What Causes This Error

Door seal/gasket damage

high

The rubber seal around the door is torn, warped, or dirty, allowing water to escape.

Overfilling or improper loading

high

Overloading blocks spray arms or causes water to splash out of the tub.

Pump or hose connection leak

medium

A hose clamp has loosened or a pump gasket is worn, causing a drip.

Tub or sump crack

low

The inner tub or sump housing has cracked, allowing water to seep out.

Repair Guide

How to Fix Error LE

1

Identify the leak location

Run a short cycle and watch where water appears. Front = door seal. Underneath = hose or pump. Back = supply line.
2

Check the door seal

Run your finger along the entire door gasket. Feel for tears, hard/brittle spots, or gaps. Clean the seal with soapy water and a cloth — buildup prevents a good seal.
3

Inspect hose connections

Unplug the appliance and look at every hose connection underneath. Tighten any loose clamps. Look for drips or mineral deposits (white crusty buildup) at connection points.
4

Check for proper loading

Make sure spray arms can spin freely and nothing is blocking them from turning. Overloaded racks deflect water in unintended directions.
5

Inspect the tub/sump

Look inside the bottom of the tub with a flashlight for cracks. Check the sump area underneath the appliance.
6

Replace the door gasket or tighten fittings

Door gaskets usually just press-fit into a channel around the door. Hose clamps can be tightened with pliers or a screwdriver.